Click the Chord tab to the left of the on screen keyboard to access the Chord controls. The LEDs in the tab light to show which layer chord mode is currently enabled on.
Chord modes turns each key pressed in to a set chord, with the pressed key as its root.
Select one of the 18 preset chords to play. Right-click this parameter to see the full list.
Strum plays each note of the chord out one at a time and holds them until you release a key. Increasing the strum value will slow down the rate of the notes triggering. A value of 0% will trigger all notes in the chord together.
This setting switches the Chord behaviour to work either before or after the Arpeggiator. If set to pre, the arpeggiator will play the notes of the chord individually.
<aside> ⚠️
Note that the Strum parameter does not operate in pre if the arpeggiator is on.
</aside>
When set to post-arp, the arpeggiator itself will start triggering chords.