Use this section to apply an independent XLFO and/or XADSR to almost any of Prophet~5’s main instrument parameters. First, click on the knob for the parameter that you wish to modulate; you’ll see red selection corners surrounding the slider or knob to indicate it is the target for the XLFO and XADSR.
<aside> ⚠️ Think of XMods as a unique and separate LFO and Envelope for each parameter on the main synth. It is not one extra mod source that you send, but an LFO and envelope per parameter.
</aside>
Then apply an XLFO amount via the XLFO Amount knob and/or an XADSR amount via the XADSR amount knob. A red corona line surrounds the knob as you turn up the amp value.
There is almost no limit to the amount of separate XLFOs and XADSRs you can apply, and by using the Copy and Paste buttons, it’s easy to apply the same settings to different parameters. However, you cannot apply an XLFO or XADSR to switches.
Use the COPY button to copy ALL current modulation settings (both X-LFO and X-ADSR) into the internal clipboard.
Use PASTE to apply copied settings to another slider parameter. This is very useful to duplicate modulation settings across many slider parameters quickly.
Use the CLEAR button to set all X-LFO and X-ADSR controls to their default value. Essentially off. Holding cmd (Mac) or ctrl (PC) and clicking Clear will clear and reset all XMod assignments in the patch.
This section provides control over the X-LFO parameters and waveforms. Whenever a Sequential Prophet~5 knob parameter is affected by an additional X-LFO, it will have a red corona around its edge. The current status of the modulation will be shown by a dot on the corona line.
When illuminated the XLFO rate and fade in controls are synchronised to the host tempo.
When illuminated the XLFO wave cycle will reset with each new note on. You can adjust the position of the wave cycle start with the phase parameter.