This sets the tune of each layer +/- 12 semitones. This is a stepped parameter; for finer control, use the Detune knob. Speaking of which…
Adjusts the volume level for the selected Layer. Layer A and Layer B can have independent volumes.
This sets the fine tune range for the selected Layer from between +50 and -50 Cents. Layer A and Layer B can have independent Detune settings.
Sets the Pan position for the currently selected Layer. Using this, it’s possible to create big, wide sounds. Try panning Layer A to the left and Layer B to the right.
Sets the depth, or amount, of tape wow effect. Turning this dial up will progressively increase the amount of pitch modulation you hear.
Sets the centre rate of the Wow effect. From 0.1HZ to 4Hz.
Sets the depth, or amount, of tape flutter effect. Turning this dial up will progressively increase the amount of pitch modulation you hear.
Sets the centre rate of the Flutter effect. From 10Hz to 70Hz.
This randomises the wow and flutter rates subtly to create complex instabilities in the tape’s pitch.