The two buttons in the top left corner enable the effect for SEM 1 and 2 respectively.
When lock is enabled the effect parameters won’t change. Also holding effects over patch switching.
Progressively adjusts the reverb size from a small room to a large hall.
This changes the length of the reverb tail, i.e. the time taken for the reverb to fade away.
With a zero value at 12 o’clock, turning this knob anti-clockwise applies a Low Pass Filter to the Reverb signal, allowing the low frequencies to sound while progressively filtering out the higher frequencies. Turning it clockwise applies a High Pass Filter to the Reverb signal, allowing the high frequencies to pass through while progressively filtering out the lower frequencies.
This allows you to adjust the “brightness” or “darkness” of the reverb and, in turn, simulate dampened or live rooms.
Adjusts the level of the Reverb.
<aside> ⚠️
The following parameters are only accessible on TVS Pro’s Sequencer/FX View.
</aside>
Right-clicking on this gives access to five factory reverb presets, providing a good starting point for your settings. Click the upper or lower area of the window to cycle options or right-click for a menu.