The MIDI Mod tab provides the modulation drag and drop crosshairs for any of the MIDI modulation sources. As well as a few settings to control them.

These settings are global affecting all voices together.

Pressure Rise and Fall

You can think of these as Attack and Release times for pressure, especially useful in MPE mode where pressure is likely to be controlling the voice amplitude.

These controls smooth out the transition of values coming in from Pressure. An high rise value will create a slow attack time if pressure is applied quickly, a low rise value will allow pressure to increase at the rate of the key press.

Fall works for decreasing values. With a high fall value, you’ll hear a slow transition to zero if you release the key quickly.

Key Track Start

Sets the note at which the keyboard outputs zero modulation. All notes to the left of this key will send zero and their connected mod destinations will be unaffected.

Key Track Range

Sets the number of keys above the start note that it takes for the modulation to hit maximum. Keys to the right of this zone will send maximum modulation to their connected destinations.

MPE Timbre Curve

Applies an exponential (positive) or logarithmic (negative) curve to MPE Timbre signals.

MPE Timbre Smooth

Applies smoothing to MPE Timbre signals, slowing down quick transitions. Dial to taste depending on your MPE controller.