The impOSCar3 has a built-in Chorus, Stereo Delay, and Reverb effects. Each effect can be turned on or off via the red LED in the top left of each effect section. It’s also possible to lock any or all of the effects so that you retain your current effects settings even when changing patches. To activate the Lock, click on the padlock at the top-right of each effect, whereupon it’ll become ‘greyed out’.
The chorus depth is defined as the intensity of which the chorus modulates. Depth is specifically the range between the maximum and minimum values.
The chorus mode switch is related to how pronounced and prominent the modulation is. Higher mode (intensity) settings create a more noticeable and "bigger" chorus effect, while lower intensity settings produce a subtler, more transparent effect.
The chorus rate denotes the speed at which these shifts occur from maximum to minimum (i.e. Chorus Depth).
Controls the amount of chorus applied to your impOSCar3 Patch.
The high-pass filter (HP) knob allows you to filter out the low frequencies in the Delay Feedback and let the high-frequency feedback pass through.
The low-pass filter (LP) knob allows you to filter out the high frequencies in the Delay Feedback and let the low-frequency feedback pass through. You can fine-tune the delay feedback in conjunction with the Highpass Filter so that your sound retains its depth without becoming too muddy.
Sets the delay time for the left and right channels from between 1 and 32 units. Use these to create wide stereo delays.
This icon activates the Cross-feedback mode.